NEC EXP320P, Руководство пользователя

Страница: 27 / 89

Precautions for Use (Be Sure to Read)
Express5800/R320c-E4, R320c-M4 User's Guide
27
Handling precautions
(
for proper operations
)
Be sure to observe the following precautions for the proper functioning of the server. Ignoring the
precautions
may cause server malfunction or failure.
Installation site

Install the server in an appropriate place. Refer to Chapter 2 Preparations (2. Installation and
Connection) .

Do not use any cell phone or PHS and switch off them near the server. Electric waves from such
devices can cause server to malfunction.

Regularly clean the server to prevent various types of failure. (Refer to Chapter 1 Maintenance (2.
Daily Maintenance) in " Maintenance Guide " for details about cleaning.)

When you store the server for a long time period, keep it under storage environment conditions
(Temperature: –10 to 55°C, Humidity: 20 to 80%, non-condensing).

Turn off the server and unplug the power cord before moving it.

In the following cases, check and adjust the system clock before operation.
– After transportation
– After storage
– After the server is used following a period of disuse, in which storage conditions did not conform
to those that guarantee server operations (temperature 10 to 35°C, humidity 20 to 80%)

Check the system clock approximately once per month. Use of a time server (NTP server) is
recommended if high accuracy timing is required by the system.
Power suply

Connect the provided power cord to a 100 VAC outlet.

Connect the dedicated power cord to a 200 VAC outlet.

Momentary voltage drop may occur due to lightning strike. To prevent this, use of UPS is
recommended.
The server does not support UPS connection via serial port (RS-232C) and power control by
PowerChute Plus.
Power-on/Power-off

Wait for at least 30 seconds before turning on the server after connecting the power cord to the
outlet.

If a Uninterruptible Power Supply unit is connected, set it to wait for at least 30 seconds before
turning on the server.

Do not press the POWER switch to turn on the server before the POWER LED (amber) is unlit.

Do not power off or reset the server, nor disconnect the power cord before POST completes.

Make sure that the access LED is off before turning off the power or ejecting an optical disk.

Wait for at least 30 seconds before turning on the server after turning off the server.

When disconnecting power cord from outlet, wait at least 30 seconds before connecting the power
cord.

For stable operation, it is recommended to restart OS after the system has been duplexed.