NEC EcoPowerGateway N8142-36F, Руководство пользователя

Страница: 88 / 136

4-18 Configuring Your EcoPowerGateway
Option Parameter Description Your Setting
Thermal Sensor Disabled
[Enabled] Specify whether the temperature sensor
monitoring feature is enabled or disabled. If a
thermal error is detected with this item being
set to "Enabled", the system stops at the end
of POST.
BMC IRQ Disabled
[IRQ 11]
Specify whether to assign IRQ for BMC
(Baseboard Management Controller).
Post Error Pause Disabled
[Enabled]
Specify whether POST is aborted once at the
end of POST if an error occurs during the
execution of POST.
AC-LINK Stay Off
[Last State]
Power On Specify the AC-LINK feature. Shows the
system status when the AC power is supplied
again to the EcoPowerGateway. See the
table below.
Power ON Delay
Time (Sec) [20] - 255 Specify the power-on delay time between 20
and 255 seconds. This option is available
only when "Power On" or "Last State" is
specified for AC LINK.
Platform Event
Filtering Disabled
[Enabled] Specify whether the Platform Event Filtering
feature of the Baseboard Management
Controller (BMC) is enabled or disabled.
[ ]: Factory-set
The table below shows the operation when the DC power to the EcoPowerGateway is turned off
once and then on again, depending on the setting of "AC-LINK".
When the DC power to the EcoPowerGateway is turned on, the standby power is supplied to the
Maintenance Card.
Setting of AC-LINK System status before DC power off of
EcoPowerGateway
Stay Off Last State Power On
Operating Off On On
Aborting (power of the Maintenance Card being off also) Off Off On
Forced shutdown Off Off On
* Press the Maintenance switch continuously at least four seconds. This forcibly turns off the
power.