NEC DLP CINEMA NC2500S, Руководство по установке, Страница: 43 / 134

NC2500S 3. Projector Adjustment and Connection
A-40
[1]
Press the “ZOOM+-” buttons on the
remote control panel or of the
projector to roughly adjust the
screen size so that the screen height
and the image height are the same.
[2]
Press the “FOCUS+-” buttons of the
remote control or the projector to
roughly adjust the focus.
[3]
Adjust the surface on which the
projector is set up and the tilt foot of
the projector to adjust the setup
position, height, and tile (front-back
and left right) of the projector so
that the projected image is level at
the screen center.
[4]
Use the “ZOOM+-” buttons again to
adjust the screen size so that the
projected image is kept 0.5 to 1
crosshatch cell portions higher than
the top edge of the screen.
[5]
Finally adjust the focus using the
“FOCUS+-” buttons either of the
remote control or the projector.
Note
•
If you use the lens memory for adjustment of the focus, first move the key (Focus
Down) almost to the limit and then make adjustments so that you can finish the
adjustment on the (Focus Up) side.