NEC DLP CINEMA NC2500S, Руководство по установке, Страница: 23 / 134

NC2500S 2. Settifng Up Your Projector
A-20
2.2 Projector installation
Move the projector to the projection position and install it corresponding to the screen and
projection conditions.
By mounting an exclusive pedestal (NC-PD01 separately sold) and tilt feet, you can adjust
the tilting angle. For adjustment of the tilting angle, refer to the pedestal (NC-PD01) manual.
To correct the inclination to the right or left of the projector, use the level adjusters at 4
positions. You can extend the level adjuster to 10mm at the maximum (Rotate it
counterclockwise for extension).
Memo
•
If you use the pedestal (NC-PD01), the projector is fixed to the pedestal. In this case,
correct the inclination to the right or left of the projector using the level adjusters on the
pedestal side.
Caution
To adjust the level adjusters of the projector, extend the two level adjusters at
the front and the back at the same time so that the weight is imposed to them
equally. If you adjust only one adjuster, the weight is not imposed equally, which
may result in level adjuster failure.
2.2.1 Mounting a lamp power supply unit to the pedestal
This section describes the procedure to mount the lamp power supply unit to the pedestal
(NC-PD01). If you do not use an installation base, proceed to “2-3. Connecting the power
cord” (Page A-22).
Execute the work below with referring to the NC-PD01 installation manual.
[1]
Remove the covers at the back
and side back of the pedestal.
Level adjusters
Tilt foot