NCR P1235 e*SmartClock Installation Guide, Ver. 1.1
US-IT Restaurant Architecture Team
Page 9 of 37 12/6/16
7.2
Installation of e*SmartClock Bracket
Step
Step Description
Pictures
1
Installation is a Flat mount on the wall.
•
Wall Mount with Bracket dimensions are
approximately 17” width x 20” height
•
The mounting wall MUST incorporate
Plywood Backing, Cement Board, and/or
Wooden Studs. There are 4 wall mounting
points for the bracket
•
At least 2 points must be installed to a stud
unless anchors are being used
•
Non-studded mounting points must contain
Molly bolts or anchors
•
Special consideration is needed if mounted
on Tile, or on an FRP surface
WARNING
Do not mount unit over a heat or moisture
source!
2
Locate following parts from Wall Mount
Assembly kit
•
Wall Mount Bracket
•
Monitor Mount Bracket
•
AC Adapter Bracket
•
Power Brick Bracket
3
Attach the Wall Bracket
•
Position the wall bracket at an appropriate
height. Keep ADA requirements in mind
regarding height
•
Secure the VESA Adapter (with UP arrow
pointing up) to the vertical surface using
lag screws (4)
•
Use the bracket as a template to mark the
location of the holes or use the dimensions
shown
•
Make sure you install the screws into the
studs or that you use hardware of similar
strength
Note
: The wall bracket must be position so a
crew member can use the e*SmartClock while
standing.
VESA Adapter
4
Attach the Power Supply Bracket beside the
VESA Adapter.
•
Loosen the screws (2) of the VESA Adapter.
•
Hook the Power Supply Bracket over the
screws. Retighten the screws.
