1
SAFETY INFORMATION
CAUTION:
DVD/VIDEO CD/CD PLAYER IS A CLASS 1 LASER PRODUCT. HOWEVER THIS DVD/
VIDEO ,CD/CD PLAYER USES A VISIBLE LASER BEAM WHICH COULD CAUSE
HAZARDOUS RADIATION EXPO SURE IF DIRECTED. BE SURE TO OPERATE THE
DVD/VIDEO CD/CD PLAYER CORRECTLY AS INSTRUCTED.
WHEN THIS DVD/VIDEO CD/CD PLAYER IS PLUGGED TO THE WALL OUTLET, DO
NOT PLACE YOUR EYES CLOSE TO THE OPENING OF THE DISC TRAY AND
OTHER OPENINGS TO LOOK INTO THE INSIDE OF THIS PLAYER.
USE OF CONTROLS OR ADJUSTMENTS OR PERFORMANCE OF PROCEDURES
OTHERTHAN THOSE SPECIFIED HEREIN MAY RESULT IN HAZARDOUS
RADIATION EXPOSURE.
DO NOT OPEN COVERS AND REPAIR YOURSELF. REFER SERVICING TO QUALIFIED
PERSONNEL
THIS DEVICE IS INTENDED FOR CONTINUOUS OPERATION!
TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, AND ANNOYING
INTERFERENCE, USE THE RECOMMENDED ACCESSORIES ONLY.
WARNING:
-TO PREVENT FIRE OR SHOCK HAZARD. DO NOT USE THIS PLUG WITH AN
EXTENSION CORD. RECEPTACLE OR OTHER OUTLET UNLESS THE BLADES CAN
BE FULLY INSERTED TO PREVENT BLADE EXPOSURE.
-TO PREVENT FIRE OR SHOCK HAZARD. DO NOT EXPOSE THIS APPLIANCE TO RAIN
OR MOISTURE.
CAUTION
-
LASER RADIATION WHEN OPEN, DO NOT STARE INTO BEAM.
VENTILATION WARNING
-
THE NORMAL VENTILATION OF THE PRODUCT SHALL
NOT BE IMPEDED FOR INTENDED USE.
Always follow basic safety precautions when using electrical products, especially
when children are present.
WARNING:
To avoid the risk of electrical shock, make sure the product is unplugged from
the electrical outlet before relocating, servicing, or cleaning it.
C A U T I O N
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION: TO REDUCE THE RISK
OF ELECTRIC SHOCK. DO NOT
REMOVE COVER (OR BACK).
NO USER SERVICEABLE PARTS
INSIDE. REFER SERVICING TO
QUALIFIED SERVICE
PERSONNEL.
The lightning flash and
arrow head within the
triangle is a warning
sign alerting you of
dangerous voltage
inside the product.
The exclamation
point within the
triangle is a warning
sign alerting you of
important instructions
accompanying the
product.
Before requesting service for this player, check the chart below for a possible cause of the
problem you are experiencing. Some simple checks or an adjustment on your part may
eliminatethe problem and restore proper operation.
TROUBLESHOOTING
Symptom(Common)
Remedy
No power.
Insert the AC adaptor securely into the power outlet.
The picture will be somewhat distorted at times: this is
normal.
Picture is distorted during rapid
advance or rapid reve rse.
No rapid advance or rapid
reverse play
Some discs may have sections which prohibit rapid
advance (or rapid reverse.)
Play fails to start even when
PLAY is pressed.
Play starts but then stops
immediately.
Condensation has formed: wait about 1 to 2 hours
to allow the player to dry out.
This pla yer cannot play a disc othe r than DVD, VCD and CD.
The disc may be dirty and may require cleaning.
Ensure that the disc is installed with the label side up.
No picture.
Ensure that the equipment is connected properly.
No sound.
Distorted sound.
Ensure that the equipment is connected properly.
Ensure that the input setting for the TV and stereo system
are correct.
32
SPECIFICATIONS
Specifications are subject to change without notice.
Power requirements:
AC 100 -240V~ 50/60Hz
Power source:
AC adaptor (normal: DC12V)
Power consumption:
≤
18
（
）
Discs played:
(1) DVD-VIDEO disc
W
Resolution:
480 RGB
*234
Dots Distance
:
0.107x0.370mm
Visible Range:
154.08x86.58mm
12 cm single-sided,single-layer
12 cm single-sided,dual-layer
12 cm double-sided,single-layer
8 cm sinle-sided,single-layer
8 cm single-sided,dual-layer
8 cm double-sided,single-layer
(2) Compact disc(VIDEO CD)
12 cm disc
8 cm disc
Video output level:
1 V
p-p
Audio output level
: 1.2V
Earphone output level:
(1KHz , 0dB, 1.25mW )
Pickup:
Wave length: 655nm
Laser power: CLASS-1
Operating Temperature Range:
-5 C to 45 C
o
o
Operating Humidity Range:
0%
80%
to
Measurement:
210 x 180 x 41mm
Weight:
Approx. g
No operations can be performed
with the remote control unit.
Check the batteries are installed with the correct polarities.
The batteries are exhausted: replace them with new ones.
Point remote control at the remote control sensor and operate.
Operate the remote control unit at a distance of not more than
6 m from the remote control sensor.
Remove the obstacles between the remote control and remote
control sensor.
No key operation (by the main
unit and/or the remote control
unit) is effective.
Press POWER to set the player to the standby mode and then
back to ON. Alternatively, press POWER to set the player to
the standby mode, disconnect the power adaptor and then
reconnect it. (The player may not be operating properly due to
lightning, static electricity or some other external factor.)
