Version 18.02.2022
HW:CAM(V100)/(V47)
RL4-MBMC
P
a
g
e
15
2.5.
After-market rear-view camera
The red power supply output
ACC/front cam out 12V (max 3A)
can be used to power the
rear-view camera. If Dip 1 is set to ON (of the black 8 dips), the power supply output supplies
+12V (max 3A) when the reverse gear is engaged and additionally
10 seconds delay after reverse gear is disengaged.
Connect
the 12pin power cable’s female
12-pin connector to the male 12-pin
connector of the video interface.
Connect the revers light power cable to the green switch input cable
"Reverse-signal
input +12V - +24V"
of the 12-pin interface cable.
Note:
To tap the reversing signal, connector
X2.52/52
is located near the head unit.
The 24V reverse signal is located on
pin52
of this 52-pin connector.
Connect the rear-view camera power cable to the red wire
"ACC/front cam out +12V
(max 3 A)"
of the 12-pin interface cable.
Connect the negative cable of the reversing camera to the vehicle
’s negative Ground
ground.
