Version 18.02.2022
HW:CAM(V100)/(V47)
RL4-MBMC
P
a
g
e
12
2.4.2
Connection - 31pin PNP cable (
analogue without CAN-bus
)
Cut the blue and grey wires of the enclosed 31-pin PNP cable close to the 10-pin connector
and insulate the four cable ends.
Connect the enclosed 31pin PNP cable’s female 10pin connector to the male 10pin
connector of the video interface.
Disconnect the female 31pin connector of the factory harness at the rear-side of the head-
unit and connect it to the male 31pin connector of the enclosed 31pin PNP cable.
Connect the opposite female 31pin connector of the enclosed 31pin PNP cable to the
previously become free male 31pin connector of the factory head-unit.
Attention: For analogue connection (without CAN bus), the violet wire of the 12-pin
interface cable must also be connected to +12V or +24V ACC accessory power.
(see chapter
„
Connection
–
switching input by 12pin interface cable (with analogue
connection without CAN-Bus
)“.
