Version 18.02.2022
HW:CAM(V100)/(V47)
RL4-MBMC
P
a
g
e
11
2.4.
Installation with connection to CAN bus or analogue (without CAN bus)
Note:
The RL4-MBMC can be integrated via CAN bus as well as operated in analogue mode
without CAN bus.
When integrated via CAN bus by the 31pin PNP cable, the interface is switched on by the
vehicle’s CAN
-Bus.
In case of CAN bus incompatibility or to comply with vehicle manufacturer policies, an
analogue connection without using the vehicle’s CAN
-BUS is also possible. In this case, via
+12V switch inputs, the interface is switched on
(see
“
Connection - 31pin PNP cable analogue without CAN-bus
”
)
or
„
Connection - 10pin power cable analogue without CAN-B
us“
.
2.4.1
Connection - 31pin PNP cable (
with CAN-bus
)
Connect the enclosed
31pin PNP cable’s female 10pin connector to the male 10pin
connector of the video interface.
Disconnect the female 31pin connector of the factory harness at the rear-side of the head-
unit and connect it to the male 31pin connector of the enclosed 31pin PNP cable.
Connect the opposite female 31pin connector of the enclosed 31pin PNP cable to the
previously become free male 31pin connector of the factory head-unit.
