4 |
P a g e
UCI Installation
T
OOLS REQUIRED
Phillips head screwdriver
Plastic pry tool
Small pocket screwdriver
*Refer to online document for vehicle specific installation*
1.
Detailed disassembly instructions for the 300, Charger, Dart and Journey
are available at
http://navtv.com/page/17/manuals.html
under the
Video Input and Backup Camera section. The Dart has three separate
disassembly documents and takes longer than the other 3.
2.
Gain access to the back of the radio head. Pull out the radio enough to access the wiring behind the radio
. On all
vehicles BUT THE DART the radio is low in the dash. In the Dart the radio is in the glove box.
3.
Disconnect the factory white 22 pin connector from behind the radio/gateway. This connector supplies Power
and ground as well CAN communication to the radio.
4.
In the kit is a 22 pin T-harness. Connect the removed harness from the
radio to the female receptacle of the supplied harness. Take care not to
bend any of the pins in the female receptacle when inserting.
5.
Plug the male plug of the T-harness into the radio where the factory
connector was located. If any other cables were disconnected when the
radio was removed, plug them back into the radio. Slide the radio gently
back into the opening and route the extension harness with the 18 pin
connector up behind the monitor. Do not secure the radio with the
factory screws until the installation has been completed and tested.
