natus OLYMPIC STERILE-DRIER 43, Инструкция по эксплуатации, Страница: 21 / 62

OLYMPIC STERILE-DRIER Model 43/44 Instruction Manual 3-3
Operating the Drier
Main Power Switch
Use the main power switch to turn the device power on or off (see Figure 3.2).
Temperature Control
The thermostat controls air temperature within the drying cabinet. To operate the
temperature control, push the knob in while rotating to turn the indicator from
LOW
(1) to
HIGH
(10) (see Figure 3.2).
„
LOW:
Use for heat-sensitive parts; may require longer drying times.
„
HIGH:
Use for large loads, fast drying. Use caution when drying
heat-sensitive parts.
Timer Control
The timer control indicates the duration of operation and functions as a
blower/heater on/off switch (see Figure 3.2). The timer may be set in 30 minute
increments for up to four hours, or set to operate continuously.The LED display
shows the timer and device status.
To use the timer control:
1
Press
SET
. To increase the operating time, press
SET
again; the timer advances
30 minutes each time
SET
is pressed.
2
When the timer display shows
ON
, pressing
SET
again will turn off the device.
NOTE
#
The power may be left on continuously; the control circuitry uses little power.
CAUTION
Remove parts and tubes from the Drier as soon as they are dry. Do not leave parts in the
Drier longer than necessary so as to avoid damaging heat-sensitive plastic parts.
NOTE
#
„
Press
SET
eight times for the maximum of four hours
„
Press
SET
nine times to set the unit on (for continuous operation).