Page 15 / 26
fire in the ash pan may occur.
NEVER USE GASOLINE, GASOLINE TYPE LANTERN FUEL, KEROSENE, CHARCOAL LIGHTER FLUID, OR
SIMILAR LIQUIDS TO START OR FRESHEN UP A FIRE IN THE HEATER. KEEP ALL SUCH LIQUIDS WELL
AWAY FROM THE HEATER WHILE IT IS IN USE. DO NOT BURN GARBAGE OR FLAMMABLE LIQUIDS SUCH AS
GASOLINE, NAPHTHA OR ENGINE OIL.
HOT WHILE IN OPERATION! KEEP CHILDREN, CLOTHING AND FURNITURE AWAY FROM THE HEATER.
CONTACT MAY CAUSE SKIN BURNS. YOUNG CHILDREN SHOULD BE SUPERVISED WHEN THEY ARE IN THE
SAME ROOM AS THE STOVE.
Controller Operation
1.
Plug in the electrical cord to a properly grounded 15A, 110VAC outlet.
2.
Turn the rear switch on. The controller will display the welcome screen, then the default display.
3.
Press and hold “set” to set the time & date
4.
Press “Control Mode” to cycle to the mode desired:
a.
“
Manual
” (constant heat output, adjustable level 1-5)
b.
“
Temperature
” (maintain an adjustable temperature set point, idles @ level 1 and heats @ 5)
c.
“
Weekly
” (4 programmable set points for each day of the week, idles @ level 1 and heats @ 5)
5.
Pressing “On/Off” will start the “Ignite” phase. The exhaust blower will turn on which causes the vacuum switch to
close and the igniter also turns on. Pellets will fall into the burn pot shortly and ignite in 3-5 minutes.
6.
Once the units gets up to temperature and the exhaust blower temperature sensor closes, the stove will switch to
“Heating” phase. The igniter will turn off and the room blower will turn on.
Bottom Status Icon Legend (in order of left-to-right):
Igniter On:
Exhaust Blower Running:
Auger Motor Running:
Room Blower Running:
Vacuum Switch Closed:
Hopper Lid Closed:
Advanced Controller Operation
Manual Mode
Adjust heat output level from 1-5 stalls (bars) by pressing the up and down arrows while on or off.
Temperature Mode
Adjust the temperature set point from 45 to 90 degrees by pressing the up and down arrows while on or off.
Weekly Mode
There are 4 different time sections for each day of the week with each section able to run the stove with variable
temperature set points or turn the stove off automatically. There is a minimum of 30 minutes allowed between all time
sections. For a set point change while running, the stove will shut down and re-start automatically 30 minutes later at the
Содержание NC-40
Страница 23: ...Page 23 26...
