8
3.8
Tooling Change
In order to change the tooling, first ensure that the grinder is switched off and disconnected from
the electrical source. Place all pocket weights provided in the weight holders on either side of the
VSD.
Then, push machine down by the handle in a controlled manner until the grinder is resting on the
top casters. Tap the tooling from the outside edging to remove, and install new tooling by sliding
the tooling outward.
Machine must only be tilted back on firm, level surface. There is danger of machine
falling if all weights are not used and surface is not level.
3.9
Care & Maintenance
Regular maintenance of the machine and its parts is imperative for functioning and safety.
In order to prevent unnecessary downtimes, it is recommended to keep original spare and wear
parts in stock.
The following maintenance should take place before and after every operation of
machine:
1. Clean all surfaces with a dry, lint-free cloth.
2. Inspect all electrical cables for cuts and replace damaged cords
3. Check that all electrical connections are secure and snug.
4. Inspect gear box for any signs of oil leakage.
5. Verify functionality of dead man key.
4.0 Transportation
4.1 Transportation
4.2 Transportation by Vehicle
4.3 Operation Conditions
4.1 Transportation
In order to transport the machine from a vehicle to the working area, place the pocket weights in
the weight baskets and tilt the machine back so it rests on the back casters.
When transporting the machine with hoisting equipment like a crane or a lift, check the total weight
permitted (see section 1-Dimensions). Use only qualified hoisting equipment, as well as ropes and
chains.
Do not fix any rope or chain to the handle. The machine must be placed on a pallet or platform
designed to hold the weight of the machine; the platform or pallet can then be lifted or hoisted from
the appropriate points.
