![background image](http://html1.mh-extra.com/html/national-instruments/ni-dids-2103/ni-dids-2103_user-manual_3423830017.webp)
NI DIDS-2100 Series User Manual | © National Instruments | 17
3.2.2.1 Out Of The Box Connection
This section describes how to establish a connection with the DI Driver System user interface via SCM. NI ships the
DI Driver System with an IP address of
192.168.1.100
and a Subnet mask of 255.255.255.0. The Windows PC used
to interface with the system must have a similar IP address and Subnet mask, but the IP address must be different in
the last address number. The directions below illustrate how to make the initial network connection to the system and
open the system user interface.
1. The customer must provide a Windows 7 (or later) PC with an Ethernet LAN port.
2. Install
3. Check the
or 3rd party firewall settings to allow SCM to communicate with the external
system.
controller. The DI Driver and PFI Driver modules do not need to be powered if
simply attempting to establish a connection to the user interface. Wait about 1 minute for both the
USER1
and
USER
FPGA
LEDs to start blinking.
5. Using a CAT5E Ethernet cable, connect the Windows PC LAN port directly to the Ethernet port of the
.
If the green and amber LEDs directly under the controller Ethernet port are not active, then there is no physical
Ethernet connection to the PC. Please diagnose the Ethernet cable connection problem.
6. Go to the
Windows Control Panel
and select
Network and Sharing Center
. From the Network and Sharing
Center select
Change adapter settings
from the left menu.
7. A list of network connections available on the PC will open. Right click the
Local Area Connection
port to select
Properties
.
Содержание NI DIDS-2103
