![background image](http://html1.mh-extra.com/html/national-instruments/mon-10467/mon-10467_user-manual_3459089013.webp)
Opening and Closing the Door
Caution
Disconnect external power to the MON-10467 (AC) and use the external
circuit breaker box to completely remove mains power before opening the device for
service.
Attention
Débranchez l'alimentation externe du MON-10467 (AC) et utilisez le
boîtier de disjoncteur externe pour couper complètement l'alimentation secteur avant
d'ouvrir l'appareil pour l'entretien.
Caution
Remove power to the MON-10467 (DC) before opening it for service.
Attention
Mettez le MON-10467 (DC) hors tension avant de l'ouvrir pour
l'entretien.
Notice
Do not put a load on the device door while it is open.
Complete the following steps to open and close the door of the MON-10467.
1.
Loosen the four captive screws on the door of the device with a 1/4 in. socket or 6 mm
(1/4 in.) flat-blade screwdriver.
2.
Open the door of the device slowly.
3.
Clean the gasket and gasket mating surface with a dry or damp cloth prior to closing the
device door.
4.
Close the door slowly.
5.
Tighten the four captive screws on the door of the device to 1.3 N · m (11.5 lb · in.).
Mounting
The MON-10467 must be mounted upright to a rigid surface such as a wall, panel, strut
channel, or metal post. For installations that may experience vibration, NI recommends using a
thread locking compound or lock nuts.
Each flange has several bolt locations as shown in the following figure. The flanges are 4 mm
(0.157 in.) thick. The V-notch on the rear facilitates mounting to a round surface such as a pipe
or pole using a pipe clamp bracket.
MON-10467 User Guide
|
© National Instruments
|
13