Figure 2. Antenna and Boot Parts
1
2
3
1. Antenna
2. Large boot
3. Small boot
Complete the following steps to install the antenna.
1.
Slide the large boot over the base of the antenna.
2.
Place the small boot over the RP-SMA connector.
3.
Attach the antenna to the device and tighten to a torque of 0.45 N · m (4 lb · in.).
4.
Slide the large boot down the antenna to the base.
5.
Press the large boot into place to create a snug seal.
Proximity Probe Drivers and Electronic
Accessories
You can use third-party accessories such as proximity probe drivers with the
MON-10467 (AC) and MON-10467 (DC). You can install up to two proximity probe drivers
per device using the industry-standard 2 in. by 2 in. hole pattern. Refer to the figures below for
the hole patterns on the MON-10467 (AC) and MON-10467 (DC). The MON-10467 (DC) has
additional holes for mounting a small panel and can also accommodate a DIN rail up to
254 mm (10 in.). The maximum height for accessories is 88 mm (3.465 in.) from the mounting
surface. The maximum height does not apply to CTC drivers, which should be installed using
MON-10467 User Guide
|
© National Instruments
|
15
