![background image](http://html.mh-extra.com/html/national-instruments/mmwave-ota/mmwave-ota_user-manual_710202019.webp)
Internal Connections
The internal chamber connections may differ depending on your specific application. Refer to
the following section to ensure the components within the mmWave OTA Validation Anechoic
Chamber are properly configured for system calibration.
Note
The tasks in this section are applicable for both the CATR and DFF chambers
unless otherwise noted.
Related Information
on page 9
on page 10
Connecting Internal RF Cables
1.
Connect one end of two 2.4 mm (m)-to-2.4 mm (m) cables to the interior chamber rear
bulkhead 1A and 2A ports.
2.
Route the opposite end of the cables through the correct locations on the positioner, as
shown in the following figure.
mmWave OTA Validation Test Reference Architecture
|
© National Instruments Corporation
|
19