Figure 24. IC-3173 (IP67) Front Panel
IC-3173
IP67 Industrial Controller
ISO PWR IN
5-24V
CONNECTOR 2
CONNECTOR 1
SYS PWR IN
9-30V
150W MAX
RESET
CONNECTOR 0
POWER STATUS
SS
DP
DIGITAL I/O
SS
PoE 4
PoE 2
PoE 1
PoE 3
SYNC
8
8
8
7
7
7
7
1
2
3
5
1
4
10
6
3
9
1. USB 3.0 Ports
2. USB 2.0 Port
3. DisplayPort Connectors
4. System Gigabit Ethernet Port
5. RS-232/RS-485 Serial Port
6. System Power Connector
7. Gigabit Ethernet Ports with PoE
8. 17-pin Digital I/O Ports
9. Chassis Grounding Screw
10. Isolated Power Input Connector
Connector Pinouts
The IC-3173 (IP67) provides the following connectors.
DisplayPort
Use the DisplayPort connectors to connect one or more monitors to implement a local HMI for
your controller. You can develop a single real-time VI to use for both your user interface and
system logic. For more information, refer to the
Using the Embedded UI to Access RT Target
VIs
topic in the
LabVIEW Help
. For up-to-date information about supported NI cables and
accessories, refer to the pricing section of the product page at
ni.com
.
For each DisplayPort connector you use, you must install one ferrite clip, NI part number
711856-01, approximately 25 to 50 mm (1 to 2 in.) from the end of the connector.
IC-317x User Manual
|
© National Instruments
|
29