National Flooring Equipment 8000, Руководство пользователя, Страница: 11 / 68

Machine Operation
www.nationalequipment.com Phone: 763-315-5300 11
SEAT SWITCH
The seat has a safety switch. Operator must be properly positioned for machine to run.
CYLINDER LIFT (FIGURE D)
The cylinder lift lever raises and lowers the cylinder and cutting head. After setting slide
plate to proper height, use the cylinder lift lever to set blade to proper cutting angle.
Pull back
↓
on the cylinder lift lever to raise the cutting head. Push the cylinder lift lever
forward
↑
to lower the cutting head. Continuing to push the cylinder lift lever forward and
it will adjust the angle of the cutting head. This will also jack up the front of the machine
(Figure D). This will need to be done when doing maintenance on the machine (ie: wheel
changing, front caster maintenance etc). When doing machine maintenance, besides
raising the cutting head angle, place blocks under the machine (Figure E). Never use the
cutting head only.
SHUT DOWN MODE (SHUT DOWN PROCEDURE/ TURNED OFF)
1. Move the 8000 to level ground.
2. Turn off the ignition switch and remove the key.
3. DO NOT move hydraulic levers. The hydraulic system is the brake system. Moving
levers could cause machine to roll, causing damage to machine, property damage
and/ or bodily injury.
4. Wait until motor has stopped completely.
5. Close propane tank valve (Figure F).
6. Let the engine, exhaust system and hydraulic components cool down before per-
forming maintenance on the machine.
MACHINE STORAGE
• Follow Shut Down Mode procedure.
• After engine has completely cooled down, disconnect propane line.
• Remove negative terminal on battery.
FIG. F
FIG. D
FIG. E
WARNING:
DO NOT ALTER A SWITCH OR LEVER. DO NOT DEFEAT A
SAFETY DEVICE.
WARNING:
DISARM MACHINE BY REMOVING THE CUTTING HEAD OR
DROPPING THE CUTTING HEAD TO THE FLOOR WHEN THE MACHINE IS NOT
IN USE.
Propane
Tank Valve