National Flooring Equipment 8000, Руководство пользователя, Страница: 10 / 68

Machine Operation
FIG. A
MACHINE START-UP PROCEDURE
POWER/Key Start (Figure A)
1. Open propane tank valve by turning knob CCW until fully open.
2. Operator must be seated in seat. The machine will not start unless the operator
is seated.
3. Insure that hydraulic levers are “centered”.
4. Set throttle at a quarter open.
5. Start with ignition key switch.
6. Both a Red & Green light will illuminate (Figure A). As soon as engine starts, the
red light will shut off. If the Red light does not shut off, turn machine off.
7. Adjust throttle to move to desired RPM.
THROTTLE CONTROL (FIGURE B)
1. Make sure throttle is pushed down.
2. Start
machine.
3. Adjust throttle to desired RPM by pulling up on the throttle control.
4. When at desired RPM, turn throttle friction knob counter-clockwise to hold in posi-
tion.
HYDRAULIC LEVERS (FIGURE C)
The hydraulic levers steer the machine. They are feathered spool valves. For smooth
even movement, always move levers slowly. Fast movement on control levers will result
in jerky, uneven movement.
• Move levers slowly.
• Both levers forward
↑↑
move the machine forward.
• Both levers backward
↓↓
move the machine backward.
• The left lever forward and the right lever backward
↑↓
turn the machine quickly
to the right.
• The left lever backward and the right lever forward
↓↑
turn the machine quickly
to the left.
• Only using the left or right lever forward
↑
, turns the machine slowly to the right
or left.
• Only using the left or right lever backwards
↓
, turns the machine slowly to the left
or right.
• Correcting direction while moving forward is accomplished by slightly reducing
pressure on one lever or the other while moving.
• The center position on levers causes wheels to lock-up.
• Always chock wheels and tie down machine when transporting.
FIG. B
FIG. C
Fax: 763-535-8255 info@nationalequipment.com 10
Hydraulic
Levers
Key Start
Green Light
Red Light
Throttle
Throttle
Friction
Knob