Machine Maintenance
FIG. XX
SLIDE PLATE
TO REMOVE SLIDE PLATE
1. Disconnect machine from power.
2. Remove slide plate pin. Remove cutting head bolt. Remove cylinder from slide
plate. Remove slide plate.
OR
1. Disconnect machine from power.
2. Unplug hydraulic lines from cylinder. A small amount of oil leak out of lines. Cap
lines or bleed into a container. Wipe up spillage immediately.
3. With lines removed, loosen slide plate securing bolts. Hold slide plate at the top of
the cylinder. Take Caution: slide plate will drop to the
fl
oor when slide plate securing
bolts are disengaged. Keep hands and feet out from underneath slide plate.
4. Remove slide plate, cylinder and lower cutting head support.
Take Caution:
slide plate will drop to the
fl
oor when slide plate securing bolts are disen-
gaged. Keep hands and feet out from underneath slide plate, failure to do so could cause
severe bodily injury.
RAISING OR LOWERING THE SLIDE PLATE
This will only work without a cutting head inserted in the machine. Completely loosen
slide plate bolts. Use cylinder lift lever to raise or lower machine to move slide plate up
or down.
LOWER CUTTING HEAD SUPPORT
To Remove Lower Cutting Head Support
1. Lower slide plate so cutting head hinge pin is below machine bottom. Retighten.
2. Loosen both cutting head pin set screws at the base of the lower cutting head sup-
port (hinge area).
3. Drive cutting head pin out using a punch and hammer.
4. Remove cylinder securing hex head bolt.
LEAK MAINTENANCE
All
fi
ttings on this machine are O-ring style.
1. Disconnect machine from power.
2. If a leak is detected, tighten
fi
tting with the proper wrench size. DO NOT over
tighten. Over tightening could damage O-rings.
3. If a leak still persists, remove
fi
tting and replace O-ring.
HYDRAULIC FLIUD LEVEL
To Check Hydraulic Fluid
1. Remove Breather Dip Stick (See Figure YY).
2. Check to see that Hydraulic Fluid is visible on Dip Stick.
OR
1. Remove Filler plug (See Figure ZZ).
2. Oil should be visual 2” below hole.
3. Reinsert
plug.
FIG. YY
FIG. ZZ
Fax: 763-535-8255
24
Slide
Plate
Pin
Loosen
Slide
Plate
Bolts
Loosen
Set
Screw
Cutting Head
Hinge Pin
Cutting Head
Pin
Disconnect
Drain Plug
Filler Plug
Breather
Dip Stick
Содержание 5625
