National Flooring Equipment 5625, Инструкция по эксплуатации

Страница: 19 / 64

Machine Operation
www.nationalequipment.com Phone: 763-315-5300 19
VCT TILE SET-UP
The slide plate should be adjusted to a low setting (1”) one inch off the fl oor. If goods come up easily, change to a larger Cutting Head. If goods
come up harder, use a Cutting Head from 6” to 8” with a Premium High Tempered Blade (.062) to match cutting head size. Sometimes a .094
blade may work better. If goods remove easily, a Tile Box #7074 can be used. A tile box also works for wind rowing, assists for a fast clean-up
and collection of tile debris for quick removal.
RUBBER TILE SET-UP
The slide plate should be adjusted to a low setting (1”) one inch off the fl oor. Use a Cutting Head from 6” to 14” with self-scoring blades or use
ditching method with a fl at blade.
RE-SCRAPING SET-UP
Slide plate should be set high, 6’’ to 8’’ off the fl oor. Use a Cutting Head from 8” to 27” with Scraper Blades to match cutting head size. A 15”
scrapper blade would use a 14” Cutting Head. Razor Blades are faster but a Cutting Head from 8” to 14” can be used with a Standard Blade.
Flip head regularly.
THIN COATING SET-UP
Slide plate could be set high, 6’’ to 8’’ or low 1” off the fl oor. Test to see which works best. Use a Cutting Head from 8” to 27” with Razor Blades
to match cutting head size.
WORKING OVER CONCRETE
Blade should be bevel up when working over concrete. Pretty much anything over concrete works. Try different set-ups to see which works
best. If goods come up dif
fi cult, the slide plate should be at a low setting, 1” off the fl oor. Use a smaller size blade. If goods come up easily, a
wider blade can be used.
WORKING OVER WOOD
A heavy machine cannot be used on wood sub fl oors or raised panel computer fl oors. Keep machine light, remove all weights. A weighted
machine could break through the fl oor. The slide plate should be adjusted to a low setting (1”) on inch off the fl oor. Blades should be as fl at of an
angle as possible. Use a “shoe blade”, Extra Heavy Duty Blade (these blades have a bend to them) or a regular blade, bevel up. When using a
regular blade, bending up the corners of the blade will help from the blade digging into the
fl oor. Sometimes a shank blade or a shank blade with
a carbide tip will work. Allow blade to shear material from the fl oor. The trick on wood fl oors is to run the blade fl at. Approach should be at a 45°
angle to the board. This keeps from digging into the board and hanging up at the seams.
WORKING OVER SOFT SUB-FLOOR
The slide plate should be adjusted to a low setting (1”) one inch off the fl oor. Blades should be as fl at of an angle as possible. Use a “shoe
blade”, Extra Heavy Duty Blade (these blades have a bend to them) or a regular blade, bevel up. When using a regular blade, bending up the
corners of the blade will help from the blade digging into the
fl oor. Sometimes a shank blade or a shank blade with a carbide tip will work.
CAUTION:
BLADES ARE SHARP, USE EXTREME CAUTION.
CAUTION:
NEVER CHANGE CUTTING HEAD OR SERVICE BLADES WHILE MACHINE IS RUNNING.
WARNING:
DISARM MACHINE WHEN MACHINE IS NOT IN USE. REMOVE THE CUTTING HEAD OR DROP CUTTING HEAD TO THE
FLOOR. FAILURE TO DO SO COULD CAUSE SEVERE BODILY INJURY.