National Flooring Equipment 5625, Инструкция по эксплуатации

Страница: 27 / 64

Machine Maintenance
www.nationalequipment.com Phone: 763-315-5300 27
CHANGING FILTER (FILTER SHOULD BE REPLACED YEARLY)
1. Place pan or rag below fi lter to catch excess hydraulic fl uid.
2. Unscrew fi lter by hand or with wrench.
3. Use excess hydraulic fl uid to lubricate seal on new fi lter.
4. Hand tighten replacement fi lter.
Do not over tighten fi lter, should only be hand tightened.
CHANGING ENGINE AIR FILTER
See enclosed Kawasaki Manual
ENGINE MAINTENANCE
See enclosed Kawasaki Manual
SWITCHES
There are two switches:
• On (Start) Switch
• Seat Switch
Do not defeat switches
SEAT REPLACEMENT
1. Remove four (4) button hexhead screws on each side of the hood (4 times).
2. Slightly raise seat plate & unplug wire harness.
3. Lift hood off.
4. Remove
seat.
5. To replace seat, set seat on top of hood.
6. Replace the four 5/16 button hexhead screws from underneath the hood.
7. Firmly
tighten.
8. Reconnect back-up beeper and seat switch wires.
9. Replace hood and screws.
CASTER MAINTENANCE
1. Keep clean and free of debris, make sure it can move freely.
2. Give a shot of grease in grease zerc on caster every six months to keep moving
freely.
3. To remove caster, machine will need to be raised. Push the cylinder lift lever for-
ward to lower and adjust the angle of the cutting head to jack up the machine (See
Figure AD). Block up machine (See Figure AE). Remove four bolts, pull caster off,
clean/replace as needed.
4. Replace caster.
5. Replace and fi rmly tighten the four bolts.
6. Lower the machine.
NOTE: A SPACER IS NEEDED WITH CASTER WHEN USING AN 18 INCH WHEEL.
FIG. AD
FIG. AE
CAUTION:
THE BACKUP BEEPER IS ON THE MACHINE FOR SAFETY. IT IS
IMPORTANT TO KEEP IT IN GOOD WORKING CONDITION. FAILURE TO DO SO
COULD CAUSE BODILY INJURY.