National Cycle, Inc.
PO Box 158 Maywood, IL 60153-0158 USA
P: 708-343-0400 / F: 708-343-0625 / E: [email protected]
www.nationalcycle.com
©2021 National Cycle, Inc.
Page 03 of 13
10-118625-000 03/21
PREPARATION AND ELECTRICAL WIRING; CONT’D.
Figure 03
Insert a step drill bit into your drill as shown (or 3/4 hole saw) and drill a
hole in the body cover at the location marked in
Figure 02
.
Figure 04
The finished hole should measure 3/4" in diameter.
Figure 05
Take the UTV Reservoir/Pump Assembly
(I)
and position it inside the vehi-
cle’s body, under the dash on the driver’s side as shown. Using a marker,
mark inside the holes of the Reservoir’s mounting tabs.
Figure 06
Using a 1/16" (2mm) drill bit, drill two holes at the locations marked in
Figure 5
.
Figure 07
Start one Machine Screw
(J)
and Flat Washer
(K)
into the right side mount
tab of the Reservoir, then...
Figure 08
...guide it into the forward drilled hole inside the vehicle’s cab. Using anoth-
er Machine Screw
(J)
and Flat Washer
(K)
, attach the Reservoir’s rear
mount tab to the rear drilled hole in the vehicle’s cab.
Figure 09
The UTV Reservoir/Pump Assembly is now securely mounted.
Figure 03
Figure 03
Figure 05
Figure 06
Figure 07
Figure 08
Figure 09
