National Cycle, Inc.
PO Box 158 Maywood, IL 60153-0158 USA
P: 708-343-0400 / F: 708-343-0625 / E: [email protected]
www.nationalcycle.com
©2021 National Cycle, Inc.
Page 12 of 13
10-118625-000 03/21
Figure 42
WIPER ARM AND BLADE
Your Wash'n'Wipe Windshield is equipped with a quality silicone Wiper
Blade. Replacement Wiper Blades are available from your local dealer or
by contacting National Cycle.
Replacement Wiper Blade Part Number is N30900.
Replacement Wiper Arm Part Number is N309
1
1.
REPLACING THE WIPER ARM AND WIPER BLADE
Figure 42
Open the small access cover on the Wiper Blade
(C)
and pull the blade
towards the motor end of Wiper Arm to loosen blade.
To install a new Wiper Blade, join the end of the Wiper Arm
(B)
to the
Wiper Blade. Place the J-hook of the Arm over the Blade’s plastic mounting
clip until it clicks and locks into place. Close the small access cover.
Figure 43
To remove the Wiper Arm
(B)
, open the Wiper Arm cover and remove the
Internal Tooth Lock Washer and Small Mounting Nut (M8 Stud Hardware
Kit H) with a 13mm wrench or socket. Then remove the Wiper Arm from the
Wiper Motor
(A)
Spindle.
To replace the Wiper Arm back on the Spindle, reinstall the Internal Tooth
Lock Washer and Small Mounting Nut.
Figure 44
With a Torque Wrench and 13mm Socket, tighten the Small Mounting Nut
to 16 ft-lbs. (22Nm). Then swivel the mount cover of the Wiper Arm back to
its closed position.
Figure 43
Figure 44
Access Cover
