23
NARVON
Caution! Any operation on the lid must be
carried out manually. Do not use any tool, as
they might damage the lid or its components.
The lid top “V” is assembled to the clear
bottom “X” by applying pressure with your
hand. To disassemble it, hold the top “V” with
one hand, while you pull the bottom “X” with
the other hand.
7.8.1. Bulb replacement
The bulb must be replaced only when the
main switch is in position -0- and power cord
is unplugged.
Lift off cover “S” as shown in Figure 44 and 45. Remove
bulb “U” from bulb holder “T” and replace it with the new
one. Replace cover “S” on lid top “V”, making sure it closes
properly.
7.9. Cleaning the condenser
The condenser should be cleaned solely by a
specialized technician.
Periodically clean the condenser situated inside the
machine.
Warning: Removing safety guards will expose
some sharp surfaces on the machine.
Warning: Failing to clean the condenser will
impair machine performance.
To access the condenser, remove the safety guards.
It is forbidden to use the machine when even
only one panel (front, rear or side) is not set
properly in place.
7.9.1. Cleaning the condenser for
#378SM1
Carefully unscrew and remove the rear panel to expose the
condenser (the screws are positioned on the left and right
sides).
After removing the panel, use a dry brush to remove the dust
that has built up over time with use.
Once the condenser has been thoroughly cleaned, fit the
panel back in position.
7.9.2. Cleaning the condenser for
#378SM2 and #378SM3
Unhook the safety clips fastened onto the panel and remove.
Fig. 45
Fig. 46
Fig. 47
Fig. 48
