NAPCO GEM-P800, Руководство по установке

Страница: 26 / 28

WI850D GEM-P800 Installation Instructions
26
9. Transmitters not responding?
Open Transmitter case; keypad
should go into X-Mitter Tamper
Trouble. If not:
• Verify Receiver Red LED is flashing
approximately once a second.
• Check Receiver wiring.
• Check Programming of Transmitter
ID.
If Keypad does go into X-Mitter
Tamper Trouble, check:
• Transmitter point is programmed
correctly.
• Transmitter is wired correctly:
• If using external switch, make sure it
is wired to point 1, and that point 2
is jumped out.
• If using internal reed, make sure J1
is cut and that both Point 1 and
Point 2 terminals are jumped out.
10. Keypad LED's Flicker.
The Keypad is not receiving a POLL
from the Panel.
• Check Keypad wiring.
• The Panel is in the process of being
Uploaded/Downloaded.
• The panel is powering up. LED’s
will flicker until panel has reset and
is polling the keypad.
• The connection from the control
panel to the keypad is open.
11. No Keypad Entry Sounder during
Entry Time?
The keypad sounder is turned off with
the A9 command. This
command will silence all Keypad
sounds except keypad sounder on
alarm. Enter
A9
to turn
keypad sounds back on.
12. No Keypad Chime?
The keypad sounder is turned off with
the A9 command. This
command will silence all Keypad
sounds except keypad sounder on
alarm. Enter A9 to turn
keypad sounds back on.