Nanni N9.330 CR2, Руководство оператора

Страница: 63 / 108

63
S08 MAINTENANCE
DRAINING THE ENGINE OIL
OIL DRAINING:
1. Start the engine and let it warm few minutes to
render oil more fluid to ease suction.
2. Stop the engine and remove the key from the panel.
3. Remove the oil cap.
4. Open the tap at bottom of pan and pump used oil.
5. Close the tap.
6.
Refill with oil.
Oil drain tap.
Oil cap.
CHANGING THE OIL FILTER
Replace the oil filter every time the engine oil is drained.
1. Remove the oil filter with a filter wrench tool. Turn the
filter counter-clockwise (CCW). Remove the gasket.
2. Apply clean engine oil to the new filter at the inner (B)
and outer seals and to filter threads.
3. Wipe both sealing surfaces of the header with a
clean cloth. Ensure that the notches in dust seal) are
properly installed in the slots of the housing. Replace
4. Install and tighten oil filter by hand until firmly
againstdust seal. DO NOT apply an extra 3/4 to 1-1/4
turn after gasket contact as done with standard
filters.Tighten drain plug to specifications :
5. Start the engine and let it operate few minutes at idle.
Check if the oil pressure warning lamp turns off.
6. Stop the engine, wait for the engine to cool down and
check the oil level. Top up if necessary.