Nanni N9.330 CR2, Руководство оператора

Страница: 66 / 108

66
DRAINING THE COOLANT CIRCUIT
1. Stop the engine and remove the key from the panel.
2. Put a container under the drain plugs to collect
coolant. Unscrew the plugs and remove the filler cap
on top.
3. Drain off all coolant. Empty the recovery container as
well as the hoses.
4. Insert a hose into the heat exchanger filler port. Rinse
with fresh water until water which flows from the
drain port is clean.
5. Reinstall the drain plug, secure it and fill with new
coolant as explained on next paragraph..
COOLANT - FILLING
Mix the anti-freeze with water in a clean container before
filling the heat exchanger. The coolant must be totally
free from dust. Fill the exchanger slowly not to introduce
air into the coolant system.
Refer to the chapter TECHNICAL DATA to know the
coolant capacity of the heat exchanger. For Keel Cooling
system or when using a water boiler, the coolant capacity
must be adapted according to the pipes length and the
tank capacity.
HOW TO FILL THE COOLANT SYSTEM:
1. Check that the drain plug ) on the side of the engine is
properly tightened.
2. Add coolant through the heat exchanger filler port on
top. Stop filling when coolant is reaching the bottom
of the filler cap lip.
3. Close and secure cap.
4. Start the engine and let it operate few minutes at
idle. Stop the engine, wait few minutes and check
the coolant level in the heat exchanger and in the
expansion tank. Top up if necessary.
CAUTION !
If a boiler is connected to the engine, follow the filling
procedure given by the manufacturer of the boiler. If
the boiler is above the engine in the boat, first fill the
heat exchanger, the boiler, and top up with coolant the
recovery tank located above the boiler.
Make sure not to overfill the heat exchanger when filling
with coolant. If too much coolant has been added, drain
part of the coolant.
S08 MAINTENANCE