English
User's Manual
of GLC001
Version 1, July 2023
- 14 -
5. parameter adjustment knob key
6. quick centrifuge key (flash)
7. stop / start key
8. door opening button
9. centrifugal time setting display
10. head turning number display
11. speed setting display
12. display of the maximum centrifugal force at the maximum speed of
rotating head No
13. storage setting display area
14. centrifugal force setting display
15.accel/decel: speed up / speed down gear display
16. volume setting display
Opening and closing status display
5.2 Power on
Connect one end of the attached power cord to the power socket on the rear wall of
the machine, and the other end to the mains power supply. The mains power supply
should use an independent socket. The power supply range used by this machine is
AC220V 50hz/60hz. After connecting, turn on the power switch located on the right
side of the rear of the machine. The buzzer gives a short sound, the LED display on
the control panel lights up, and after the self-test of the machine is completed, enter
the main interface, and now you can carry out the next operation.
5.3 open
Press the door open key
on the control panel, the door cover will
automatically open and pop up to a certain height under the action of the damping gas
spring, and then you need to lift the door cover up by hand to fully open the door
cover, and the inner cavity will be presented to the user.
Note: when opening the door, the door cover will automatically pop up to a
certain height. At this time, heads or other objects should be prevented from above the
door cover to avoid danger!
In case of failure, the door cover cannot be opened automatically. At this time, if
the objects in the chamber must be taken out, the method of manually opening the
door can be adopted. See "failure treatment" for details.
5.4
关门
Press the door cover down until the front door hook on the door cover slides over
the lock pin and hears a click. The bottom of the door hook will contact the travel
switch and the door has been locked.
When closing the door, press the door cover properly
