Electrical connection
The appliance is fitted with a plug and must only be connected to a properly installed earthed socket.
Only a qualified electrician who takes the appropriate regulations into account may install the socket
or replace the connecting cable. If the plug is no longer accessible following installation, an all-pole
isolating switch must be present on the installation side with a contact gap of at least 3 mm. Contact
protection must be ensured by the installation.
Oven door seal
If water droplets or food debris get stuck in the door seal, wipe it with a soft cloth after wringing out the
water.
WARNING Do not scratch or remove the seal as the steam spills easily.
Wipe the enclosure with a cloth dampened with a soft detergent (such as detergent), wipe it off with a
damp cloth, and finally wipe with a dry cloth. Do not wipe the product with a hard ob
j
ect such as a wire
brush. Do not clean the door safety lock system.
WARNING Do not use a rough scrubbing agent or a sharp metal scraper to clean the glass of the oven
door, which may cause the glass to shatter.
Always keep the door and the body
j
oint clean.
The grease produced during cooking can corrode the chamber and affect the heating effect, thus
changing the taste of the food. Therefore, please clean the oven chamber with a damp cloth or a cloth
dampened with a soft detergent when the chamber has fully cooled down.
Clean accessories with warm water regularly. Do not clean with cold water immediately after cooking for a
long time.
Do not wipe the oven with poor cleaning agent or corrosive, volatile chemical solvent to avoid damage to
the oven.
EN-5
