(Revised 4-9-2013) NT24k Managed Industrial Ethernet Switch User Manual & Installation Guide Page 35 of 132
Configuration Page
The Configuration section of web management gives an administrator the ability to save a running
configuration into the NVRAM. This step is needed in order for the switch to remember any changes after a
power cycle.
The “Save” button will save all current changes to the configuration for use after the next power cycle. If a
configuration device is installed, the configuration will also be saved to the device.
Selecting the “Restore” button will discard all unsaved changes, and load the most recently saved
configuration settings.
Selecting the “Reboot” button reboots the switch and reloads the most recently saved configuration. If a
configuration device is installed, the configuration stored on the device will be loaded and used.
The “Factory” button resets the switch's configuration to factory defaults except for any of the user
selectable items below. If a configuration device is installed, Save Configuration is then necessary to update
the configuration stored on the configuration device.
