System Board
Section 1
Installation
Installation
There are 5 easy steps for installing the MVE486
system board into a chassis.
1.
2.
3.
4.
5.
Planning the system configuration.
Installing SIMM memory.
Changing any of the hardware jumpers, if the
system configuration requires them to be
changed.
Installing the board into the chassis.
Powering-up the system and setting the
CMOS configuration information.
Planning the System
Using the simple form located in Appendix A, the
resources available can be planned and any problems
such as hardware conflicts can be avoided ahead of
time. It would be a good idea to complete this form
before system assembly is performed.
Installing Memory
The MVE486 provides four 72-pin SIMM sockets ca-
pable of taking single as well as double sided
The MVE486 supports different SIMM sizes. All
should be 60 or 70 NS
Please see the
following table for the possible configurations.
l - 4
Version DO1
Copyright 1993
