section 9 ~ adding a myerson
DurAcetal clasp to a cast metal
removable partial denture framework
The following procedure outlines the steps necessary to create myerson
DurAcetal
clasps on a cast metal framework.
1. Using CDM brand Thermoplastic Model Separator paint the area
on the model where the clasp will touch. Be sure to wear eye
protection and use proper air ventilation. Avoid skin contact.
Once separator has dried, place partial framework on the model.
The myerson
HotShotElite
handheld clasp injector is for indoor use
only. Do not use outdoors or in wet or damp locations.
Never immerse
device in water or other liquids. Use only on a clean, dry work
surface
.
Excessive dust and dirt will reduce the life of the device.
Use only recommended accessories and materials with this device.
Using materials other than those recommended by myerson, LLC
may result in accidental injury and permanent damage to the device.
When not in use, device should be stored in a dry secure location
out of the reach of children.
Manufacturer assumes no responsibility for consequential or indirect
damages from the use of this product.
6
Burn Hazard Caution/Warning
•
myerson HOTSHOTELITE MANUAL ENGLISH.indd 6
3/23/10 9:54:26 AM
