14. Take the model and putty out of the oven, place the tip of the
injector into the putty indent and squeeze the trigger once and
hold the trigger in the pulled position keeping pressure on the
injection for 5 seconds. Do not repeatedly pull the trigger.
IF CREATING A SECOND CLASP ON THE SAME PARTIAL,
REMOVE THE INJECTOR FROM THE PUTTY, CLEAN THE
TIP, AND ALLOW THE INJECTOR TO SIT FOR ONE MINUTE.
THEN INJECT THE SECOND CLASP FOLLOWING THIS
SAME PROCEDURE.
15. Expel the remaining material onto the Elite injector stand and
remove the injection rod. While wearing heat resistant gloves,
remove sleeve and nozzle from injector and place on metal
stand to cool.
Refer to Section 5 for more information regarding cleaning of
the sleeve and nozzle. Let the model bench set for about
10 minutes or until the model is cool to the touch.
16. Section the putty matrix using a thin bladed knife. Cut a section
of the putty with the knife and using an instrument, pry off the
pieces of the putty until all the putty is removed. Notice the
button of material on the lingual side. This if from the vent hole
created in step 5 of this section.
19
myerson HOTSHOTELITE MANUAL ENGLISH.indd 19
3/23/10 9:55:01 AM
