MUTOH Rockhopper 38, Руководство по обслуживанию

Страница: 97 / 258

Rockhopper 38 – Maintenance Manual
97
AP-74038, Rev. 1.1, 25/01/05
Step 12 :
Remove the Head an disconnect the Head Cable.
Step 13 :
Remove the Cable from the Head.
Step 14 :
To install removed components, reverse the removal procedure.
Caution:
Before the new head is fitted, check the head rank (the five digits of the number on
the side of the head are the rank) and write the number with a marker pen on the
black head cable (Delete the old head rank by drawing two lines trough the
number).
When fitting the head into the head mount, put the black head cable on top.
Adjustments:
1. Reset the head nozzle ejector count
Please refer to “How to Initialize Parameters”
2. Carry out initial filling.
Please refer to “How to enter Head Rank”
CAUTION :
Wait at lease 30 minutes after the initial filling before printing. Otherwise the printing
quality can not be assured.
3. Carry out the Print Head (Colour) Tilt Adjustment
Please refer to “Adjusting the Tilt of the Print Head(Colour)”
4. Carry out a test print
Please refer to “Test Procedures, Test 2”.
5. Fit a new Waste Fluid Box
Pleas refer to “How to enter Head Rank”
CAUTION:
About 100 cc of waste fluid will be expelled into the Waste Fluid Box from head cleaning
and initial filling. Fit a new Waste Fluid Box.
Please refer to “Replacing Waste Fluid Box”.
The message “Change Tank?” will appear on the panel display. You should confirm by
answering “YES”
CAUTION:
Head board assembly connectors J201 (MAIN1) and J202 (MAIN2) should be plugged
in securely. The main board may be damaged if power is applied when they are not
properly connected.