MUTOH Rockhopper 38, Руководство по обслуживанию

Страница: 176 / 258

Rockhopper 38 – Maintenance Manual
176
AP-74038, Rev. 1.1, 25/01/05
8.1.2 How to move to a different building by vehicle
A serviceman must bring the following items and follow the procedure set out below.
• Main unit packing box
• Vinyl bag
• Head fastening plate (ME-24632) and wing bolt (DE-48262)
• Cable keeper (DF-40338) and lever keeper (DF-40337)
• Waste fluid box (Number RJ8-HEB)
• Head cleaning jig
• Packing tape, gum tape, bubble wrap
• PP strapping and stopper (for long distance transportation)
Caution:
• For safety, always have two people to dismantle and assemble the printer.
• Always have two people to transport the printer and load and unload it on the vehicle.
• If the user wishes you to take away the waste fluid box that has been removed and the
packing used for transportation, remove them.
• After the move, carry out the initial filling and wait at least 30 minutes before printing
otherwise printing quality can not be assured.
Step 1 :
Remove the four cartridges.
Step 2 :
Carry out head cleaning. (Refer to REP1620)
Step 3 :
With power off, bring the head to the home position and attach the head fastening plate with the
wing bolt.
Step 4 :
Remove the power cable and interface cable.
Step 5 :
Remove the waste fluid box and install a new one.
Step 6 :
Install the cable keeper and lever keeper and fasten them with packaging tape.
Step 7 :
Attach packaging tape so the front cover will not open and the waste fluid box will not come out.
Step 8 :
Remove the main unit from the legs, place it in the packing box and apply gum tape and PP
strapping.
Step 9 :
Don’t dismantle the legs. Wrap them in bubble wrap. (Remove the tray assembly and wrap it
separately) (If it needs to be dismantled to fit in the vehicle, dismantle and wrap each piece
separately.)
Step 10 :
Transport by vehicle and on arrival at the destination, refer to the basic “Printer Preparation” in
the operation manual and make sure it is printing correctly.