MUTOH Rockhopper 38, Руководство по обслуживанию

Страница: 191 / 258

Rockhopper 38 – Maintenance Manual
191
AP-74038, Rev. 1.1, 25/01/05
No Message Explanation N° Checkpoint Action
1.1 • Check how the cutter cap is fitted → Fit the cutter cap
securely
1.2 • Check the up and down
movement of the cutter. With the
cutter installed, push it down tot
the bottom with your fingers and
check that the power of the spring
alone brings it back to the top
→ If it rises, go to 1.4
→
If it does not rise, go to
1.3
1.3 • Remove the cutter and take out
the cutter spring. Fit the cutter and
check that in this condition, the
cutter will fall to the bottom under
its own weight.
→
If it falls the cutter spring
may be faulty. Refer to the
exploded drawings and
replace the cutter spring.
1.4 • Check the contact of the cutter
solenoid assy. Head board
J206(SOL)
→
Insert it correctly
1.5 • Check the up and down
movement with the printer’s self-
diagnostic “Aging: Cutter”
→
If it does not move up and
down, the solenoid may be
damaged. Replace the
cutter solenoid assy.
1.6 • The head board assy may be
damaged
→
Replace it
1.7 • Check the Y cable contacts. Is it
inserted obliquely? Check. Main
board J111 (HEAD1), Head Board
J201 (MAIN1)
→
Insert it correctly
1.8 • The main board assy may be
damaged.
→
Replace it
1 Media Cut Error This message
is displayed
when the
media is not
cut and goes
not fall out
despite the
cutting
operation
having been
performed.
1.9 • The Y cable (A0/A1) may be →
Replace it
damaged.
Caution :
Main board connectors J111 (Head 1) and
J112 (Head 2) and head board connectors
J201 (Main 1) and J202 (Main 2) should be
plugged in securely. The main board may
be damaged if power is applied when they
are not properly connected..