IceDry 800/1400
requirements for the equipment in order to achieve the best possible performance and facilitate servicing.
Therefore, comply with the recommended service spaces, see section
8.1, Dimensions and service space
NOTE!
The unit must be removed from the cold store at certain service intervals. Have extra cables for unit
connection available.
4.4 Mirror handed duct connections
The front and back panels are interchangeable, so that the connections for process and dry air may be
situated either on the left or right side of the unit.
The dehumidifiers are delivered with the process and dry air connections on the left side of the unit. If it is
required to the change the orientation, so that the connections are on the right side of the unit, proceed
as follows.
W
W
WARNING!
ARNING!
ARNING!
Ensure that main power is isolated from the dehumidifier prior to changing the orientatin of the process and dry air
connections.
B
A
C
D
E
F
1. Remove the two bolts (B) securing the front panel and carefully remove the panel.
2. Remove the two bolts securing the rear panel and carefully remove the panel.
3. Remove the two bolts (A) and washers securing the control and top panels, then carefully remove the
top panel.
4. Remove the cable duct covers (C), re-route the cables and fit the control panel (D) onto the opposite side
of the unit. Refit the cable duct covers.
5. Loosen the rotor stop (E) and the two filter monitors (F). Remove the cable ties.
6. Fit the rotor stop and filter monitors on the opposite side of the unit. Tie the cables.
7. Fit the front, rear and top panels in their new positions.
190TGB-1037-G1307
Installation
7
