2
About the on-board integrated display/controller
Functions of the on-board integrated display/controller
8
V3.20151130_rev.2
30283620-02-EN
About the on-board integrated display/controller
Functions of the on-board integrated display/controller
DRILL-Control is an on-board integrated display/controller.
A job computer is built into the on-board integrated display/controller, which can control the work of
seeders. When a job computer is mentioned within these instructions, it always refers to the DRILL-
Control on-board integrated display/controller.
Among other things, the on-board integrated display/controller can perform the following tasks:
▪ Monitoring of the metering shaft
▪ Control of the bout marker
▪ Control of the tramline valves
▪ Starting the calibration using the calibration button
▪ Control of the half width shutoff system
▪ Control of the pre-emergence marker
▪ Monitoring of the fan speed
System overview
The following diagram shows an example of how an implement can be structured:
DRILL-Control
Tramline valve
Cable harness
Revolution sensor
Calibration button
Radar sensor
Fill level sensor
Bout marker
Fill level sensor
Work position sensor
Electrical metering drive
Pre-emergence marker
2
2.1
2.2
