MTZ 1220.1/1220.3
Section H. Adjustments
H4
Rear wheel track formation
1. Jack up the rear part of the tractor so
that the wheels leave the ground.
2. Unscrew the nuts (1) and remove the
wheels.
3. Loosen by 2…3 turns the tie bolts (2)
of the upper and lower wheel hub liners
(3).
4. With the four extracting bolts
screwed into the upper and lower liners
(two bolts on each liner), pull the liners (3)
from the wheel hub to release the cone
clamp and wheel hub to let the hub move.
5. Move the hub along the semi-axle to
obtain the required track L (use the tables
at the right side to determine the track by
measuring the size K from the semi-axle
end to the liner end).
6. Remove the extracting bolts and
tighten up the bolts fastening the hub.
7. Install the wheel and repeat the
operation for the opposite rear wheel.
Wheel truck formation when doubling
the rear wheels
To install the hubs (basic and additional
ones) of the external and internal wheels
relative to the semi-axis of the rear axle
and wheels disks, follow figure H-2.
Rear wheels toe-in is adjusted steplessly.
y
z
{
|
y
y
z
z
{
{
|
|
y
z
{
|
y
z
{
|
Fig. H-2.
Table H-2
Track L, mm
Distance K, mm
Wheel installation
pattern
(for tyres 11,2R42)
A
B
245
1420
—
205
1500
—
155
1600
—
55
1800
—
5
1900
—
245
—
1950
220
—
2000
170
—
2100
Track L, mm
Distance K, mm
Wheel installation
pattern
(for tyres 18,4R38)
A
B
1650
133
-
1800
58
-
200
-
222
2150
-
147
B
Содержание 1220.1
