MTZ 1220.1, Руководство оператора

Страница: 188 / 244

MTZ 1220.1/1220.3 K. Scheduled technical maintenance
K8
Operation 3. Oil level in hydraulic sys-
tem tank
Before you check the oil level, install the
tractor on a flat, horizontal surface. Stop
the engine and brake the tractor with the
parking brake.
Check the oil level in the hydraulic system
tank by the oil gauge glass (1) on the left
side of the tractor. The level should be be-
tween the marks “0” and “
П ”, and for ma-
chines that require high intake of oil, at the
level of mark “
С ”. As necessary, add oil to
the level of the mark “ П ”, removing the
threaded cap (2).
ATTENTION! If you want to refill a hy-
draulic system unitized with machines
having single-acting cylinders, the cy-
linders of the machines and the hitched
device must have their rods pulled in.
Operation 3a. Oil level in HSU tank
Check the oil level in the HSU tank (5) by
performing the following operations:
• Remove the filler neck cap (3);
• Remove the strainer (4) from the filler
neck;
• Check the oil level by the strainer,
which must be between the filter bottom
(the lower limit) and the middle of the
strainer (the upper limit). As necessary,
add oil until the middle of the strainer.
Operation 4. Transmission oil level
Check the oil level by the oil-gauge glass
(1) on the right side of the GB, following
the requirements set forth in the Operation
3. The oil level must be between the
marks “0” and “
П ”. As necessary, add oil,
removing the oil filler neck cap (2).
14836
Max.