MTZ 1220.1/1220.3
Section G. Operating instruction
G7
Note: For HLL with hydraulic lift the lift
linkage is bringed to the lower position
with the handle of position control, by
doing so the handle of draft control is to
be in the extreme front position. Com-
bine hinge pins of lower links with im-
plement pins and connect the imple-
ment to the lower links.
2.
Удлините
или
укоротите
верхнюю
тягу
(3)
и
соедините
шаровой
шарнир
тяги
с
орудием
.
Зашплинтуйте
палец
.
. Lengthen or shorten the upper link (3)
and connect the same to the implement
by means of the rear joint. Lock the pin
with a linchpin with a ring.
3. If necessary, adjust the upper link to the
required length.
4. If necessary, adjust the sideways tilt of
the implement by means of the right-
hand crossbeam (1). To increase the
crossbeam length, turn the lever (2)
clockwise and vice versa.
5. Attach the necessary remote mount
equipment.
6. Prior to beginning the work, check to
make sure that:
• the parts of the tractor is not in dan-
gerous vicinity of those of the imple-
ment;
• the upper link is not in contact with
the PTO enclosure when the imple-
ment is in the bottom position;
• the cardan drive from the PTO is not
too long with large joint angles and
there are no thrust forces;
• the PTO is not in contact with the
cardan drive of the machine;
• lift slowly the implement and check
the presence of the clearances be-
tween the tractor and the implement
in the lifted position;
• check the presence of the required
side swinging of the lower rods and
adjust it be means of the tie-links, if
necessary.
IMPORTANT! When mounting the
mounted or semi-mounted equipment
on the tractor or when hitching the
trailed equipment to the tractor by
means of the draft hitch, make sure that
there is a sufficient clearance between
the implement and the tractor.
CAUTION! Some mounted or semi-
mounted equipment can touch the cab
and damage the same. It could cause
the breakage of the cab glasses and in-
jure of the operator. Check the presence
of a sufficient clearance (at least 100
mm) between the implement lifted to the
top position and the tractor cab.
Содержание 1220.1
