MTZ 1220.1, Руководство оператора

Страница: 30 / 244

MTZ 1220.1/1220.3 Section D . Operation controls and instruments
D10
2. When the “Value” button is pressed repeatedly, the numerical value of the set pro-
grammed parameter is changed.
3. When neither the “Parameter” nor “Value” button is pressed for 7.0 seconds, the
mode is exited automatically.
When exiting the mode, the parameter values selected with the “Value” button are
stored.
List of programmed ratios(graphic examples of parameter presentations and their val-
ues in the programming mode):
“Z” parameter
Z is the number of teeth of final shaft gears of the driving wheels
(right and left), at which the travel speed (rotation speed) sensors
are installed.
.
“I” parameter
I is the gear ratio multiplier of the wheel-hub drive;
“R” parameter
R is the rear wheel rolling radius, mm (is the value for tires
18.4R38. If other tire types are installed, set the “R” value corres-
ponding to the rolling radius of the installed tires);
“
К ” parameter
K is f generator drive transfer ratio;
“KV2” parameter
KV2 is the PTO gear ratio;
“ZV” parameter
ZV is the teeth number of the PTO speed sensor gear;
“V” parameter
V is the fuel tank volume, (l).