MSA FireHawk M7, Инструкция по эксплуатации и руководство пользователя, Страница: 29 / 56

USING THE AIR MASK
Use only Rayovac 814 or AL-C (Regular/Max or
Ultrapro), Duracell MN1400, or Duracell Procell PC1400
alkaline batteries in the FireHawk M7 Power Module.
Use of other batteries, or a combination of batteries
from different manufacturers, will affect the perfor-
mance of unit and void the Intrinsic Safety Approval.
1. Unthread the battery cap on the FireHawk M7 Power
Module by rotating the battery cap in the counter-
clockwise direction.
2. Remove the four C batteries from the battery tube of
the FireHawk M7 Power Module.
3. Inspect the inside of the battery tube. Ensure that the
battery terminals are not corroded and that the tube is
free of moisture and debris.
4. Insert four C batteries following the diagrams inside
the battery tube.
5. Verify that the o-ring on the battery cap is held in
place, free of damage and debris, and not twisted in
the gasket retention groove in the battery cap. If o-ring
is missing or damaged, it must be replaced.
6. Install the battery cap on the FireHawk M7 Power
Module battery tube. Tighten the battery cap by rotat-
ing it clockwise until it is fully seated. Failure to fully
seat the battery cap may prevent the battery tube
from being water tight.
7. Dispose of, or recycle batteries, in accordance with all
applicable federal, state, and local regulations.
Turning OFF the FireHawk M7 Control Module after
Doffing the Air Mask (integrated PASS version)
Turn the FireHawk M7 Control Module off after doffing
air mask; otherwise, batteries will be drained. The
FireHawk M7 Control Module does not shut off auto-
matically.
1. Upon returning to fresh air, close the cylinder valve
completely and release all pressure from the air mask.
2. When the pressure falls below 200 psi, turn the
FireHawk M7 Control Module off by pressing the reset
button (yellow) two times within approximately one
second.
a. The FireHawk M7 Power Module will beep once when
the reset button is pressed once. Pressing the reset
button a second time will then sound three beeps
(“bee-bop-bop”) to indicate that the unit is turned off.
The lights on the FireHawk M7 Control Module and
FireHawk M7 Power Module will stop flashing.
REPLACING BATTERIES IN THE CLEARCOMMAND
COMMUNICATION SYSTEM
In continuous service, battery life will vary depending on
user conditions. The battery is not rechargeable.
Use only 1.5 Volt Duracell MN2400 or Energizer E92
AAA alkaline batteries. Use of other batteries, or a
combination of batteries from different manufacturers,
will affect performance of the unit and will void the
intrinsic safety approval. Failure to follow this warning
can result in serious personal injury or death.
1. Loosen the thumbscrew to open battery door.
2. Ensure that the battery compartment is free of mois-
ture or debris.
3. Insert two AAA batteries according to the battery ori-
entation noted inside the compartment door.
4. Close the battery door and tighten the thumbscrew.
Battery Disposal/Recycling
Dispose of or recycle batteries in accordance with all
applicable federal, state, and local regulations.
Do not dispose of the battery in fire. It may explode.
Failure to follow this warning can result in serious per-
sonal injury or death.
29 TAL 1705 (L) Rev. 18 - 10082858