Handling the Remote Controller
Page 3
mrcool.com
2
TIPS FOR USING REMOTE CONTROL
NOTES FOR USING REMOTE CONTROL
• The remote control must be used within 26 ft
(8 m) of the unit.
• The unit will beep when remote signal is
received.
• Curtains, other materials and direct sunlight
can interfere with the infrared signal receiver.
Remove batteries if the remote will not be
used more than 2 months.
Inserting and Replacing Batteries
BATTERY NOTES
BATTERY DISPOSAL
The device should comply with the local
national regulations.
• In Canada, it should comply with
CAN ICES-3(B)/NMB-3(B).
• In the USA, this device complies with part 15
of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful
interference, and
(2) this device must accept any interference
received, including interference that may
cause undesired operation.
This equipment has been tested and found to
comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide
reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses, and radiates radio
frequency energy. If it is not installed and used
in accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that
interference will not occur in a particular
installation. If this equipment does cause
harmful interference to radio or television
reception, which can be determined by turning
the equipment off and on, the user is
encouraged to try to correct the interference
by using one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet on a
circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced
radio/TV technician for help.
• Changes or modifications not approved by
the party responsible for compliance could
void user’s authority to operate the
equipment.
Your air conditioning unit may come with two
batteries (some units). Install the batteries in the
remote control before use by following the steps
below:
1. Slide the back cover from the remote control
downward to expose the battery compartment.
2. Insert the batteries, making sure to match the (+)
and (-) designations on the end of the batteries
with the symbols inside the battery compartment.
3. Reinstall the back cover by sliding it back into
place.
For optimum product performance:
• Do not mix old and new batteries, or
batteries of different types.
• Do not leave batteries in the remote
control if the device will not be used for
more than 2 months.
DO NOT
dispose of batteries as unsorted
municipal waste. Refer to local laws for
proper disposal of batteries.
