Operation Of Buttons
Page 4
mrcool.com
Easy Pro™ Remote Controller
3
Before you begin using your new air conditioner, make sure to familiarize yourself with its remote
control. The following is a brief introduction to the remote control itself. For instructions on how to
operate your air conditioner, refer to the
How to Use Basic Functions
section of this manual.
Buttons and Functions
ON/OFF
Turns the unit on or off.
SET
CLEAN
LED
TURBO
ECO/GEAR
FAN SPEED
SWING
Increases temperature in
1°F (1°C) increments.
Maximum Temperature
setting is 86°F (30°C).
NOTE: Press together &
buttons at the same
time for 3 seconds will
alternate the temperature
display between °C & °F.
Scrolls through operation
functions in following
sequence:
Sleep
( )
Follow Me
( )
AP Mode
( )
The selected symbol will
flash on the display window,
press the OK button to
confirm.
Decreases temperature
in 1°F (1°C) increments
Minimum temperature
setting is 60°F (16°C).
TEMP
TEMP
Starts and stops the horizontal
louver movement. Hold down
for 2 seconds to initiate vertical
louver auto swing feature.
Selects fan speeds in the
following sequence:
AU 20% 40% 60%
80% 100%
Press the
TEMP
or
button to increase or
decrease the fan speed in
1% increments.
Enables unit to reach the preset
temperature in the shortest possible
time.
Used to start/stop the Self-Clean or
Active Clean function (Model
dependent, please refer to the
USER’S OPERATION & INSTALLATION
MANUAL
).
Turns the indoor unit’s LED display
and air conditioner buzzer on and off
(model dependent), to create a quiet
environment.
Press this button to enter the energy
efficient modes which can be selected
in the following sequence:
ECO GEAR (75%) GEAR (50%)
Previous setting mode ECO
OK
Used to confirm the selected
functions.
TIMER
Used to set the timer to turn the unit
on or off at a specified time.
BREEZE AWAY
This feature keeps direct airflow
from blowing directly on the
occupants of the room.
NOTE: This feature is only available
in COOL, FAN, and DRY modes.
MODE
Scrolls through operation modes in
the following sequence:
AUTO COOL DRY HEAT FAN
NOTE: HEAT mode is not supported
by the cooling-only version.
