How To Use Advanced Functions
Page 11
mrcool.com
Sleep function( ) :
SET function
or
SET
SET
OK
Press the
SET
button to enter the function setting, then press the
SET
button or the
TEMP
or
buttons to select the desired function. The selected symbol will flash on the display, press the
OK
button to confirm and this will activate the selected function.
To cancel the selected function, just perform the same procedures as above.
The SLEEP function is used to decrease energy
use while you sleep (temperature settings
needed to stay comfortable during sleep differ
from the settings needed while awake). This
function can only be activated via the remote
control.
For further details, please refer to the
Sleep
Operation
section of your unit’s
USER MANUAL
.
NOTE: The SLEEP function is not available in
FAN or DRY mode.
Follow me function ( ):
The
FOLLOW ME
function enables the remote
control to measure the temperature at the
location it currently is and send this signal to
the air conditioning unit in a 3 minute interval.
When using
AUTO, COOL, or, HEAT
modes,
measuring the ambient temperature from the
remote control (instead of from the indoor
unit itself) will enable the air conditioner to
optimize the temperature where you currently
are and ensure maximum comfort.
NOTE: Press and hold the TURBO button for
seven seconds to start or stop the memory
feature of the FOLLOW ME function.
If the memory feature is activated, “ON”
will display for 3 seconds on the screen.
If the memory feature is stopped, “OF”
will display for 3 seconds on the screen.
While the memory feature is activated,
press the ON/OFF button, shift the mode
or power failure will not cancel the
Follow Me function.
AP function ( ) (some units):
Choose
AP
mode to use the wireless network
configuration. For some units, it does not work
by pressing the
SET
button. To enter the AP
mode, continuously press the
LED
button
seven times within 10 seconds.
Press the
SET
button to scroll through operation functions as follows:
Breeze Away ( ) Sleep ( ) Follow Me ( ) AP mode ( )
[ ]: If your remote controller has a Breeze Away button or Sleep button, you cannot use the
SET button to select the Breeze Away or Sleep feature.
*
*
This feature keeps airflow from being blown
directly on the occupants of the room.
NOTE: This feature is available under COOL,
FAN and DRY modes only.
Breeze Away function ( ) (some units):
