MQ Power WHISPERWATT Series, Руководство по эксплуатации

Страница: 27 / 42

DCA15SPXU4F • OPERATION MANUAL — REV. #1 (02/10/17) — PAGE 27
GENERATOR START-UP PROCEDURE
BEFORE STARTING
1. Place the main, G.F.C.I., and aux. circuit breakers
(Figure 24) in the
OFF
position prior to starting the
engine.
Figure 24. Main, Aux. and GFCI
Circuit Breakers (OFF)
2. Connect the load to the
receptacles
or the
output
terminal lugs
as shown in Figure 9. Tighten terminal
nuts securely to prevent load wires from slipping out.
3. Tighten terminal nuts securely to prevent load wires
from slipping out.
4. Close all engine enclosure doors (Figure 25).
Figure 25. Engine Enclosure Doors
CAUTION
The engine’s exhaust contains harmful emissions.
ALWAYS have adequate ventilation when operating.
Direct exhaust away from nearby personnel.
WARNING
NEVER manually start the engine with the main, GFCI
or auxiliary
circuit breakers in the
ON
(closed) position.
INCORRECT CORRECT
STARTING
1. Place the engine speed switch (Figure 26) in the
LOW
(down) engine speed position.
Figure 26. Engine Speed Switch (Low)
2. Insert the ignition key into the ignition switch. Turn the
key clockwise to the
PRE-HEAT
position (Figure 27A)
and observe the pre-heat lamp. is ON .
Figure 27. Ignition/Starter Switch
3. When the
pre-heat lamp
has turned
OFF
, continue
turning the ignition key clockwise to the
START
position
(Figure 27B). When the engine starts, release the key. If
engine fails to start within 10 seconds, wait 30 seconds
and repeat this step.
4. Once the engine starts, let it engine run for 1-2
minutes. Listen for any abnormal noises. If any
abnormalitiesexists shutdown the engine and correct
the problem.
5. If the engine is running smoothly, place the engine
speed switch (Figure 28) in the
HIGH
(up) position.
Figure 28. Engine Speed Switch (High)
NOTICE
In cold weather conditions warm up the engine 5-7
minutes before placing into operation.