MQ Power WHISPERWATT Series, Руководство по эксплуатации

Страница: 16 / 42

PAGE 16 — DCA15SPXU4F • OPERATION MANUAL — REV. #1 (02/10/17)
The definitions below describe the controls and functions
of the Engine/Generator Control Panel (Figure 4).
1.
Frequency Meter
— Indicates the output frequency
in hertz (Hz). Normally 60 Hz.
2. AC Ammeter — Indicates the amount of current the
load is drawing from the generator per leg selected by
the ammeter phase-selector switch.
3.
AC Voltmeter
— Indicates the output voltage present
at the U, N and V Output Terminal Lugs.
4. Engine Warning Lamp Module — This module
displays the following engine alarms: oil pressure, water
temperature, battery charging and pre-heat.
A.
Low Oil Pressure Alarm Lamp
— During normal
operation of the generator this lamp
will remain OFF. When the ignition
switch is placed in the RUN position
to start the engine, the lamp will be
ON. When the oil pressure rises
after start-up the lamp will go OFF.
If this lamp is ever lit (
ON ) during normal operation
of the generator, the emergency shutdown system
will stop the engine automatically.
Figure 4. Engine/Generator Control Panel
B. Water Temperature Alarm Lamp — This lamp
goes ON when the cooling water
temperature rises abnormally. If
the lamp goes ON during normal
operation of the generator, the
emergency shutdown system will
stop the engine automatically.
C.
Battery Charge Alarm Lamp
— This lamp is ON
when the output voltage of the
alternator drops below a set value.
If this lamp is ON during normal
operation, the emergency
shutdown system will immediately
stop the engine.
D. Pre-Heat Alarm Lamp — The pre-heat lamp will
be ON during the pre-heating cycle (cold weather
conditions). When the pre-heat
cycle is completed the lamp will
turn OFF and the engine can be
started. In addition this lamp
displays engine trouble shooting
faults via flashes (blinking). See
engine trouble codes in the maintenance section
of this manual.
ENGINE/GENERATOR CONTROL PANEL